Omron 3G3RX - Read;Write Function and Operation; R;W Storage Mode - Single READ;WRITE Function; R;W Storage Mode - Quad READ Function

3-13
3-5 Read/Write function and operation
3
Operation
3-5 Read/Write function and operation
LCD digital operator can read and save inverter parameter settings and copy them to another inverter.
Specifically LCD digital operator can save four inverter’s parameter sets or one inverter’s parameter set and its
Drive Programming. It can be selected via the R/W Storage Mode in the LCD configuration Option Mode.
Note: If Read operation cannot be executed, please check the Read Lock option in the LCD configuration Option Mode.
R/W Storage Mode - Single READ/WRITE function
When the R/W Storage Mode is selected to "01: Single" (this is done in the LCD configuration: Option Mode), the
function Read or Write is executed immediately after pressing or key.
After pressing the key in any display mode, except Write mode and Option mode, the inverter’s parameter
configuration are read and saved into LCD digital operator Drive Programming program will be transferred to the
LCD digital operator automatically after parameter reading is finished. If the inverter supports Drive Programming
function, it returns to the previous display after read function is completed.
After pressing the key in any display mode except Read mode and Option mode, the parameter settings
stored in LCD digital operator are transferred to the inverter. If the inverter supports Drive Programming, it will be
transferred to the inverter automatically after the parameter copy is finished. It will return to the previous display
after write function is completed.
R/W Storage Mode - Quad READ function
When the R/W storage mode is selected to 02: Quad option, it will be possible to handle four sets of inverter pa-
rameters or read/write an Drive Programming program independently. In this case, LCD digital operator can save
four sets of inverter parameters or one set of inverter parameters and one Drive Programming program. Please
note that one Drive Programming program takes up three sets of inverter parameters, which are No.2, No.3 and
No.4.
Note: Refer to "LCD Line Digital Operator User’s Manual" for more information.