Omron 3G3RX - External Frequency Adjustment; Accel;Decel; Operation Frequency; Acceleration;Deceleration

3-31
3-9 Parameter List
3
Operation
External frequency adjustment
A101 OI start frequency
0.00 to 400.00
0.00 No Hz
4-14
A102 OI end frequency 0.00 No Hz
A103 OI start ratio 0 to OI end ratio 20 No %
A104 OI end ratio OI start ratio to 100 100 No %
A105 OI start selection
00: Start FQ (Use OI start frequency [A101])
01: 0 Hz
00 No 
A111 O2 start frequency
-400.00 to 400.00
0.00 No Hz
4-15
A112 O2 end frequency 0.00 No Hz
External frequency adjustment
A113 O2 start ratio -100 to O2 end ratio -100 No %
A114 O2 end ratio O2 start ratio to 100 100 No %
Accel/Decel
A131
Acceleration curve
parameter
01 (small curve) to 10 (large curve)
02 No 
4-38
A132
Deceleration curve
parameter
02 No 
Operation frequency
A141
Operation frequency
input A setting
00: Operator (Digital Operator (F001))
01: VR (Digital Operator (FREQ adjuster))
(Enabled when 3G3AX-OP01 is used.)
02: O (Input O)
03: OI (Input OI)
04: Modbus (RS485 communication)
05: Option 1
06: Option 2
07: Pulse (Pulse train frequency)
02 No 
4-41
A142
Operation frequency
input B setting
03 No 
A143 Operator selection
00: ADD (Addition (A + B))
01: SUB (Subtraction (A - B))
02: MUL (Multiplication (A × B))
00 No 
A145
Frequency addition
amount
0.00 to 99.99
100.0 to 400.0
0.00 No Hz
4-41
A146
Frequency addition
direction
00: ADD (Add A145 value to output
frequency)
01: SUB (Subtract A145 value from output
frequency)
00 No 
Acceleration/Deceleration
A150
EL-S-curve ratio 1
during acceleration
0 to 50 10 No %
4-39
A151
EL-S-curve ratio 2
during acceleration
0 to 50 10 No %
A152
EL-S-curve ratio 1
during deceleration
0 to 50 10 No %
A153
EL-S-curve ratio 2
during deceleration
0 to 50 10 No %
Parameter
No.
Function name Monitor or data range
Default
setting
Changes
during
operation
Unit Page
* 2nd/3rd control is displayed when "SET(08)/SET3(17)" is allocated to one of multi-function inputs from C001
to C008.