Omron 3G3RX - Parameter Initialization

3-15
3-6 Test Run Operation
3
Operation
Parameter Initialization
•Initialize the parameters using the following procedure.
•To initialize the parameters, set parameter b084 to "2" and parameter b180 to "1".
Key sequence Display example Description
Power On
Press the Prev. Page or Next Page key until function mode is
displayed.
Press the Set key to enter function mode.
With the Prev. Page, Next Page, Up and Down keys write the
parameter b084.
Press the Set key to enter b084 parameter.
With the Prev. Page, Next Page, Up and Down keys put the
parameter b084 to 2.
Press the Set key to change the parameter b084 to 2.
With the Prev. Page, Next Page, Up and Down keys write the
parameter b180.
Press the Set key to enter b180 parameter.
MONITOR-A M1-STOP ALL
d001 Output FQ
0.00Hz
F001 0.00Hz
FUNCTION M1-STOP ALL
F001
[0.00 – 50.00]
Set Frequency (TM)
0 .00Hz
FUNCTION M1-STOP ALL
001
[0.00 – 50.00]
Set Frequency (TM)
0 .00Hz
F
FUNCTION M1-STOP ALL
084
[00 – 04]
Initialize Mode
00:no
b
FUNCTION M1-STOP ALL
b084
[00 – 04]
Initialize Mode
:no00
FUNCTION M1-STOP ALL
b084
[00 – 04]
Initialize Mode
:Parameters02
FUNCTION M1-STOP ALL
b0
[00 – 04]
Initialize Mode
:Parameters02
84
FUNCTION M1-STOP ALL
180
[00 – 01]
Initialize trigger
00:No action
b
FUNCTION M1-STOP ALL
180
[00 – 01]
Initialize trigger
:No action
b
00