Section 6 Programming Macros 6-1 Registering Macros
NS-Designer Operation Manual NS-Designer Operation Manual NS-Designer Operation Manual
6-1 Registering Macros
Macros can be registered to projects, screens, and functional objects.
Register the macro by selecting the macro execution conditions and inputting the macro program in the
Edit Macro Dialog Box.
Click the OK Button after editing the macro to execute an error check. When an error is detected, an
error message will be displayed in the error list. Refer to 6-2 List of Error Messages for details on the
messages displayed when errors occur. Macro editing cannot be exited until no errors occur.
1
2
3
4
No. Setting Details
1 Execution Condition Displays the execution conditions for the selected macro.
2 Program The field used to input the macro program. Up to 3,000 characters can be input
for one macro.
3 Select Command When a command is selected from the combo box, an explanation of the selected
command will be displayed above the combo box. Click the Insert Button to insert
the selected command in the program input field.
4 Error List Click the OK Button to display the error messages for the errors detected when
the error check is executed.
When each error in the error list is double-clicked, the cursor will move to the
position in the program input field where the error was detected.
Reference
♦ Refer to the online manual under Macro in the Manual Folder in the NS-Designer Program Folder
for information on macro programming methods. To access the manual, however, the online man-
ual option must be selected when installing the NS-Designer.
R
R
e
e
f
f
e
e
r
r
e
e
n
n
c
c
e
e
6-1
To Next Page
Loading...
Need help?
General
