Omron NS

Section 10 Transferring Data 10-2 Transferring Data to and from a Memory Card
NS-Designer Operation Manual
10-2 Transferring Data to and from a Memory Card
This section explains preparations and procedures to transfer data between a Memory Card inserted
into PT and the NS-Designer (personal computer).
10-2-1 Preparations for Transferring to a Memory Card in PT
To transfer data between a Memory Card inserted in the PT and the NS-Designer, select the transfer
method, and make the settings beforehand.
Transfer Methods
There are five methods to transfer data between a Memory Card inserted in PT and the NS-Designer:
Serial cable •
•
•
•
•
Ethernet
Modems
Controller Link
USB
Connect the PT and NS-Designer (personal computer) using either of these methods and transfer the
data. Refer to 10-1-1 Preparations and Procedures before Connecting for the features of these meth-
ods and the required cables.
Before Connecting
To transfer data between a Memory Card and the NS-Designer (personal computer) using serial,
modem, Ethernet, Controller Link, or USB communications, settings on the PT are required. Refer to
10-1-1 Preparations and Procedures before Connecting and make settings for FinsGateway.
Transfer Methods
The following operations can be performed between a Memory Card and the NS-Designer.
Memory Card → NS-Designer Transferring files stored in a Memory Card.
NS-Designer → Memory Card Transferring files stored in the computer.
Deleting files stored in a Memory Card
Creating folders in a Memory Card
Deleting folders in a Memory Card
10-29