Section 7 System Settings 7-1 Settings
NS-Designer Operation Manual
7-1 Settings
7-1-1 Common Procedure
Select Settings - System Setting. The System Setting Dialog Box will be displayed.
7-1-2 PT Operations
Click the PT Ta b.
1
2
4
3
5
6
No. Setting Details
1 Startup Wait Time Set the time required before the PT starts communicating with external de-
vices after turning ON the power or resetting the PT. The startup waiting time
can be set to between 0 and 10 (unit: s).
2 Key Press Sound Select whether an input sound will be heard when an object is pressed.
ON: Input sound enabled
OFF: Input sound disabled
3 Buzzer Sound Select whether a buzzer will be heard.
ON: The buzzer is enabled at the following times:
•
•
•
When system memory bits $SB12 to $SB14 are ON
When an error occurs in the PT
When a message is displayed for the “×” and “!” icons
OFF: The buzzer is disabled
ERROR ON: The buzzer is enabled at the following times:
•
•
When an error occurs in the PT
When a message is displayed for the “×” and “!” icons
4 Screen Saver Set the various screen saver settings.
Screen Saver
Movement
Select one of the following screen saver operations.
Display Erased: Erases the screen when it is idle for a specified time.
OFF: Disables the screen saver.
Screen Saver
Startup Time
Set the amount of time after which the screen saver will start up. The time
can be set to between 1 and 255 (unit: s).
5 Device Monitor
Changing Value
Set whether to enable or disable changing monitor values for addresses
displayed on the device monitor screen on the PT.
Enable: Monitor value can be changed.
Disable: Monitor value cannot be changed.
7-1
To Next Page
Loading...
Need help?
General
