Section 10 Transferring Data 10-3 Data Transfer Using SPMA
NS-Designer Operation Manual
Select the communications method between the
PLC and PT.
Select this option to transfer through the PLC.
Set the communications method between the
computer and PLC.
6. Click the Set… Button to the right of the communications method setting. The following Network
Setting Dialog Box will appear.
Set the Ethernet network address.
Set the network address and node
number of the PLC’s Ethernet Unit.
Input the response monitor time.
Increase the time only when there are
frequent communications error.
7. Input the Ethernet network address for the Network of the FINS source address. Here, 1 is set as
an example.
8. Input network address and node number of the PLC’s Ethernet Unit for the Network and Node of
the FINS destination address. Here, 1 is set for the Network and 6 is set for the Node as an ex-
ample.
9. Click the Driver Tab and make the following settings.
10-46
To Next Page
Loading...
