Section 10 Transferring Data 10-3 Data Transfer Using SPMA
NS-Designer Operation Manual
Transferring Screen Data
1. Click the Connect Button in the Screen Data Transfer Dialog Box. After completing the connection,
the screen on the PT switches to the following screen and the PT will wait for the data to be trans-
ferred. Here, the entire project will be transferred as an example.
2. Select Select All, and click the Button to display the Transfer Confirmation Dialog Box.
3. Click the Start Button. The download will be started.
4. The following dialog box will be displayed at the computer when the data transfer is finished. The
PT must be restarted to operate the screens that have been transferred. Click the YES Button to
restart the PT. Click the NO Button to continue downloading data.
Even if the NO Button is selected, the confirmation message shown below will be displayed when
exiting the Screen Data Transfer Dialog Box.
If the YES Button is clicked, the PT will be restarted. If the NO Button is clicked, it will become
necessary to restart the PT directly. To return to the Screen Data Transfer Dialog Box, click the
Cancel Button.
10-48
To Next Page
Loading...
