Omron NS - Page 286

Section 10 Transferring Data 10-3 Data Transfer Using SPMA
NS-Designer Operation Manual
Settings on the PT
Make the settings on the NS-Designer shown below. After completing these settings, transfer them to
the PT along with the screen data.
1. Select Settings – System Setting – Comm-All in NS-Designer.
2. Set Controller Link to Enable and click the Routing Table Setting Button. The Routing Table
Setting Dialog Box will be displayed.
3. Input 1 as the Destination Network Address, 3 as the Remote Network Address, and 4 as the
Gateway Node Address (Controller Link Unit’s node address). Click the OK Button to return to the
System Setting Dialog Box.
4. Transfer the above settings along with any desired screen data to the PT. At this time, connect the
PT directly to the computer. Perform normal screen transfer without selecting Pass Through PLC.
Setting the Communications Method
1. Open the desired project on the NS-Designer and select File - Screen Data Transfer. The Screen
Data Transfer Dialog Box will appear.
10-50