Omron NS - Page 95

Section 4 Screen Types and Operations 4-1 Basic Operations
NS-Designer Operation Manual
The following information is displayed in each functional object when Show Address is selected.
Type Functional object Display information
Button The write address, display address 1, and display address 2 are displayed in
the following format.
$B100(W)
$B101(R1)
$B102(R2)
(W: Write address; R1: Display address 1; R2: Display address 2)
ON/OFF Button
The write address is displayed in the following format.
$W100
Word Button
Command Button The set values are displayed in the following format.
• Specified screen
Switch
Screen
50(P)
$W100(W)
(P: Page number; W: Page write address)
• Indirectly specified screen
$W10(P)
$W100(W)
(P: Indirect reference address; W: Page write address)
• Selection by Pop-up Menu
POPUP
(POPUP is the fixed display.)
Command Button • Forward
PAGE+
$W100(W)
(PAGE+ is the fixed display; W: Page write address)
• Backward
PAGE−
$W100(W)
Switch
Screen
(PAGE− is the fixed display; W: Page write address)
Key Button
KEYBUTTON
Button
(KEYBUTTON is the fixed display.)
Control
Pop-up
Screen
PCTRL
(PCTRL is the fixed display.)
Display
System
Menu
SYSMENU
(SYSMENU is the fixed display.)
4-9