Omron NX Series User Manual

2 The Node Address Change Dialog Box is displayed. Enter a new IP address in New IP
address.
To apply the same change to other connections, select the Apply the change to other
connections Check Box.
3 To apply the same change to other connections, select the Apply the change to other
connections Check Box.
4 Click the OK Button.
l
Changing All Target Device Information including Model Names and Revi-
sions
1 Right-click one of the connection lines and select Change Target Device
from the menu.
2 The Target Device Change Dialog Box is displayed. Select a target device from New device.
Precautions for Correct Use
• Changeable target devices are limited to ones that have "OMRON" in the Vendor ID and is an
EDS device of the Communications Adapter in the Device Type.
•
To display a device in the list of selectable new target devices, the device must be registered
as the target device in the Toolbox.
Appendices
A-24
NX-series EtherNet/IP Unit User's Manual (W627)

Omron NX Series Specifications

General

Programming Languages	Ladder, Structured Text, Function Block Diagram, Sequential Function Chart
Communication Ports	Ethernet, USB, RS-232C, RS-485
Memory Capacity	Varies by model
Program Memory	Varies by model
Data Memory	Varies by model
Operating Temperature	0°C to 55°C
Power Supply	24 VDC
Ethernet Ports	1 or 2 ports (depending on model)
USB Ports	1 or 2 ports (depending on model)
Dimensions	Varies by model
Weight	Varies by model