Modify iSCSI Virtual Drive Properties in UEFI Boot Mode (BIOS)
The Target Name dialog box appears.
b.
Type the iSCSI Qualified Name (iqn) of the target. For example:
iqn.1988-12.com.oracle:platform-target
9.
Set the iSCSI server IP address.
a.
Select Target IP address.
The Target IP address dialog box appears.
b.
Type the target IP address of the iSCSI server in dotted-decimal notation, for
example:
192.168.1.24.
10.
Set the Target port.
a.
Select Target port.
b.
Type the target port of the iSCSI server, for example:
3260.
Note - When iSCSI is enabled on a network port, PXE is disabled for that port.
11.
Set the Logical Unit Number.
a.
Select Boot LUN.
The Boot LUN dialog box appears.
b.
Type the logical unit number. For example: 0
Configuring Storage Resources 79
To Next Page
Loading...
Need help?
General
