133
DP-C405/C305/C265
FEB 2008Ver. 1.1
(33) Place the IT Unit on its side with the side that has
the belt position mark facing upward.
(34) Bend the IT Unit at the bending point up to
maximum bending position.
Caution:
Confirm that the IT Unit is at the maximum bending
position for removing the IT Belt.
(35) Remove the IT Belt (3419).
Caution:
When Removing and installing the IT Belt, hold the
side band of the belt as illustrated. Don’t touch the
center of the belt, or the printing quality will be
affected.
Note:
While removing the IT Belt, exercise care not to
snag the belt projections onto the frame of the IT
Unit.
(36) Straighten the IT Unit.
To Next Page
Loading...
