Panasonic DP-C305 - Page 468

468
DP-C405/C305/C265
FEB 2008Ver. 1.1
E7-51 Finisher
Delivery
Motor
Finisher Delivery
Belt Home Position
Sensor does not
turn Off/On within a
predetermined time.
Finisher 1. Delivery Belt Home Position Sensor is
defective.
2. Check the wiring between the Finisher
Controller PCB, and the Delivery
Motor.
3. Stack Delivery Roller is abnormal.
4. Delivery Motor is defective.
5. PCB is defective. (Finisher Controller
PCB)
DA-
FS405/
FS356/
FS325
only
E7-52 Finisher
Paddle Motor
1. Paddle Home
Position Sensor
does not turn Off
within a
predetermined
time.
2. Paddle Home
Position Sensor
does not turn On
within a
predetermined
time.
Finisher 1. Paddle Home Position Sensor is
defective.
2. Swing Guide Home Position Sensor is
defective.
3. Check the wiring between the Finisher
Controller PCB, and the Paddle Motor.
4. Paddle, Swing Guide Assembly is
abnormal. Try turning the Paddle Motor
clockwise and counter-clockwise by
hand. Is there a mechanical tapping in
the rotation of the Paddle, or the up/
down movement of the Swing Guide?
Correct the mechanical mechanism.
5. Finisher Controller PCB is defective.
E7-53 Finisher
Saddle
Folding
Sensor
Saddle Folding
Sensor does not
detect the proper
signal to correctly
adjust the Folding
position.
Finisher 1. Saddle Folding Sensor is defective.
2. Finisher PCB is defective.
E7-54 Finisher
Punch
Communicati
on Abnormal
No response from
Punch unit within a
predetermined time.
Finisher 1. Finisher PCB is defective.
2. Punch PCB is defective.
E7-55 Finisher
Punch Power
Supply
Punch unit does not
detect +24 VDC.
Finisher 1. Punch PCB is defective.
E7-56 Finisher
Punch
Registration
Sensor
Punch Registration
Sensor does not
detect the proper
signal to correctly
adjust the Punching
position.
Finisher 1. Punch Registration Sensor is
defective.
2. Punch PCB is defective.
E7-57 Finisher
Punch
Sensor
(Horizontal
Registration)
Punch Folding
Sensor does not
detect the proper
signal to correctly
adjust the Folding
position.
Finisher 1. Saddle Folding Sensor is defective.
2. Punch PCB is defective.
E7-58 Finisher
Punch
Sensor
(Waste Full)
Punch Sensor does
not detect the
proper signal to
adjust Punching
position.
Finisher 1. Punch Sensor is defective.
2. Punch PCB is defective.
E7: Optional Unit Error Codes
Code Function Contents Section Check Points Unit