469
DP-C405/C305/C265
FEB 2008Ver. 1.1
Note:
These error codes will appear only when the optional accessories are installed. Refer to the appropriate
Optional Unit Service Manual.
E7-59 Finisher
Upper Limit
Sensor
Paper Height
detection Sensor
detects the Upper
Limit.
Finisher 1. Check the Stack Tray Paper Height
Detection Sensor, or Paper Hold Lever
Detection Sensor connectors.
2. Stack Tray Paper Height Detection
Sensor, or the Paper Hold Lever
Detection Sensor is defective.
3. Upper Limit Detection Sensor is
defective.
4. Check the Upper Limit Detection
Sensor connector.
5. PCB is defective. (Finisher Controller
PCB for DA-FS405/FS356/FS325 /
CONT PCB for DA-FS402/FS350/
FS320)
DA-
FS405/
FS402/
FS356/
FS325/
FS350/
FS320
E7-60 Finisher
Aligning:
Rear Motor
Rear Aligning Home
Position Sensor
does not detect On/
Off.
Finisher 1. Rear Aligning Home Position Sensor is
defective.
2. Rear Aligning Motor is defective.
DA-
FS405/
FS356/
FS325
only
E7-61 Finisher
Aligning:
Front Motor
Front Aligning
Home Position
Sensor does not
detect On/Off.
Finisher 1. Front Aligning Home Position Sensor is
defective.
2. Front Aligning Motor is defective.
DA-
FS405/
FS402/
FS356/
FS325/
FS350/
FS320
E7-62 Finisher
Aligning:
Stapler
Stapler Sensor
detects Stapler Jam
twice continuously.
Finisher 1. Staple Jammed in the Cartridge.
2. Stapler Sensor is defective.
3. Stapler Motor is defective.
E7-63 Finisher
Backup RAM
1 (Punch)
Data Error
Backup RAM 1 Data
on Punch PCB is
abnormal.
Finisher 1. Punch PCB is defective. DA-
FS405/
FS356/
FS-325
only
E7-64 Finisher
Backup RAM
2 (Finisher)
Data Error
Backup RAM 2 Data
on Finisher
Controller PCB is
abnormal.
Finisher 1. Finisher Controller PCB is defective.
E7-65 Finisher
Communicati
on Error (EC
PCB-Finisher
PCB)
Communication
Error between EC
PCB and Finisher
PCB.
Finisher 1. Incorrect Finisher ROM Version.
2. Incorrect EC Firmware Version.
DA-
FS405/
FS402/
FS356/
FS325/
FS350/
FS320
E7-90 Hardware
Key
Abnormal
Hardware Key is
incorrect.
Hardware
Key
1. Incorrect Hardware Key is installed.
2. Hardware Key is defective.
E7-91 Data Security
Kit Abnormal
(DP-C405 /
C354 Series)
Hardware Key (Data
Security Kit) is not
installed.
Hardware
Key
Hardware Key for Data Security Kit is not
installed.
E7: Optional Unit Error Codes
Code Function Contents Section Check Points Unit
To Next Page
Loading...
