Panasonic DP-C305 - Page 527

527
DP-C405/C305/C265
FEB 2008Ver. 1.1
068 OPC2 MTR Half Speed OPC 2 motor half of standard speed adjustment
for mixed printouts.
-99 ~ +99
0.05%
069 Not Used
070 DEV1 MTR CL STD Speed Developer 1 motor standard speed adjustment
for color printouts.
-99 ~ +99
0.10%
071 DEV1 MTR CL Half Speed Developer 1 motor half of standard speed
adjustment for color printouts.
-99 ~ +99
0.10%
072-
074
Not Used
075 DEV2 MTR B/W STD Speed Developer 2 motor standard speed adjustment
for monochrome printouts.
-99 ~ +99
0.10%
076 DEV2 MTR CL STD Speed Developer 2 motor half of standard speed
adjustment for color printouts.
-99 ~ +99
0.10%
077 Not Used
078 DEV2 MTR Half Speed Developer 2 motor half of standard speed
adjustment for mixed printouts.
-99 ~ +99
0.10%
079 Not Used
080 Feed MTR B/W STD Speed Feed motor standard speed adjustment for
monochrome printouts.
-50 ~ +50
0.10 %
081 Feed MTR CL STD Speed Feed motor standard speed adjustment for color
printouts.
-50 ~ +50
0.10 %
082 Not Used
083 Feed MTR Half Speed Feed motor half of standard speed adjustment
for mixed printouts.
-50 ~ +50
0.10 %
084 Not Used
085 IT Motor B/W STD Speed Intermediate Transfer motor standard speed
adjustment for monochrome printouts.
-99 ~ +99
0.05%
086 IT Motor CL STD Speed Intermediate Transfer motor standard speed
adjustment for color printouts.
-99 ~ +99
0.05%
087 Not Used
088 IT Motor Half Speed Intermediate Transfer motor half of standard
speed adjustment for mixed printouts.
-99 ~ +99
0.05%
089 Not Used
090 Fuser MTR BK STD Speed Fuser motor standard speed adjustment for
monochrome printouts.
-99 ~ +99
0.10%
091 Fuser MTR CL STD Speed Fuser motor standard speed adjustment for color
printouts.
-99 ~ +99
0.10%
092 Not Used
093 Fuser MTR Half Speed Fuser motor half of standard speed adjustment
for mixed printouts.
-99 ~ +99
0.10%
094 Not Used
095 Fuser MTR Half Speed L Fuser motor L half of standard speed adjustment. -99 ~ +99
0.10%
096-
123
Not Used
124 Warm UP Timer Warm up timer adjustment.
When temperature is low, rotates fuser for warm
up. If 1st print in the morning is not fusing
correctly, extend the warm up time.
value increases -> time is extended
-20 ~ +20
1sec.
F6 Mode
No. Item Remarks Setting Range