Panasonic DP-C305 - Page 528

528
DP-C405/C305/C265
FEB 2008Ver. 1.1
125 T4 tmp (color Half Spd) Color half speed Fuser temperature adjustment.
value increases -> temperature goes up
-5 ~ +5
1°C
126 T4 tmp (mono Half Spd) B/W half speed Fuser temperature adjustment.
value increases -> temperature goes up
-5 ~ +5
1°C
127 T4 tmp (color STD Spd) Color full speed Fuser temperature adjustment.
value increases -> temperature goes up
-5 ~ +5
1°C
128 T4 tmp (mono STD Spd) B/W full speed Fuser temperature adjustment.
value increases -> temperature goes up
-5 ~ +5
1°C
129 T5 tmp At standby mode temperature adjustment.
value increases -> temperature goes up
-5 ~ +5
1°C
130 OHP Min Temp OHP minimum temperature adjustment. -30 ~ +30
1°C
131 OHP Max Temp OHP maximum temperature adjustment. -30 ~ +30
1°C
132 Long Min Temp Long paper minimum temperature adjustment. -30 ~ +30
1°C
133 Envelope Min Temp Envelope minimum temperature adjustment. -30 ~ +30
1°C
134 Envelope Max Temp Envelope maximum temperature adjustment. -30 ~ +30
1°C
135 Th1 Temp (Print Start) Thermistor 1 temperature at the start of printing. 0 ~ +255
(Read Only)
136 Th2 Temp (Print Start) Thermistor 2 temperature at the start of printing. 0 ~ +255
(Read Only)
137 Th3 Temp (Print Start)
(DP-C322 Series Only)
Thermistor 3 temperature at the start of printing. 0 ~ +255
(Read Only)
138 Th4 Temp (Print Start) Thermistor 4 temperature at the start of printing. 0 ~ +255
(Read Only)
139 Not Used
140 Th1 Temp (Error) Thermistor 1 temperature when error occurred. 0 ~ +255
(Read Only)
141 Th2 Temp (Error) Thermistor 2 temperature when error occurred. 0 ~ +255
(Read Only)
142 Th3 Temp (Error)
(DP-C322 Series Only)
Thermistor 3 temperature when error occurred. 0 ~ +255
(Read Only)
143 Th4 Temp (Error) Thermistor 4 temperature when error occurred. 0 ~ +255
(Read Only)
144 Not Used
145 IH Voltage (Print Start) IH drive voltage at the start of printing. 0 ~ +255
(Read Only)
146 IH Current (Print Start) IH drive current at the start of printing. 0 ~ +255
(Read Only)
147 Cnt. Ratio (Print Start) Control ratio at the start of printing. 0 ~ +255
(Read Only)
148-
149
Not Used
150 IH Voltage (Error) IH drive voltage when error occurred. 0 ~ +255
(Read Only)
151 IH Current (Error) IH drive current when error occurred. 0 ~ +255
(Read Only)
F6 Mode
No. Item Remarks Setting Range