689
DP-C405/C305/C265
FEB 2008Ver. 1.1
3. Preparing the Host Machine for Finisher
Installation
(1) Connect the Optional LVPS Harness to
connector CN64 on the Optional LVPS.
(2) Remove 11 Screws.
(3) Remove the Rear Cover Assembly.
Caution:
If the LED on the SC PC Board is lit (ON), the
Power to the machine is still ON.
Please read the entire section “9.10.2. Installation”
once again.
(4) Release the Harness from the Harness Clamp.
To Next Page
Loading...
