691
DP-C405/C305/C265
FEB 2008Ver. 1.1
(11) Install the Finisher IPC PC Board into connector
CN535 on the EC PC Board.
Note:
Gently insert the IPC PC Board as illustrated.
(12) Install the Latch Plate.
(13) Secure the Latch Plate with 4 Screws (M3 x 6).
Note:
Before connecting the Finisher to its Host
Machine, be sure to attach the Latch Plate to the
Host Machine.
(14) Remove the 2 Protective Tabs using a Phillips
type Screwdriver as illustrated.
(15) Remove the 2 Protective Tabs using a Nipper,
or a Cutter.
4. Attaching the Finisher to the Host Machine
Caution:
Be sure install both the Finisher, and Host
Machine on a level floor. A stepped, or slanted
floor can result in improper paper feed.
(1) Fit the hooks of the Stand into the mounting
holes on the side panel of the Host Machine,
then secure the Stand with 2 Screws (M4 x 30).
To Next Page
Loading...
