702
DP-C405/C305/C265
FEB 2008Ver. 1.1
(13) Slowly move the Finisher back and forth, close
to the Host Machine, and adjust the Finisher so
that the notch of the Latch Plate aligns with the
protrusion of the Punch Base Cover.
(14) Tighten 2 Screws loosened in step (12).
(15) Attach the Finisher to the Host Machine, and
connect the Interface Cable of the Finisher to
the Host Machine.
(16) Plug the AC Power Cord into the wall outlet, and
turn the Main Power Switch on the Back, and the
Power Switch on the Left Side of the machine to
the ON position.
(17) Reconnect the Telephone Line / LAN Cable if
disconnected.
Host Machine
Latch Plate
Punch Base
Cover
Align
Finisher
To Next Page
Loading...
