701
DP-C405/C305/C265
FEB 2008Ver. 1.1
(10) Place the Punch Relay Harnesses into the
Harness Clamps and Harness Guides.
(11) Attach the Front Cover, Latch Release Lever,
Jam Release Dial, and Rear Cover.
Note:
When attaching the Front Cover, attach it with the
Side Guide being on the inside of the Front Cover.
See the illustration on the left.
If the Front Cover is attached with the Side Guide
being on the outside, the up and down operation of
Ejection Tray may malfunction.
(12) Loosen 2 Screws securing the Finisher, and
Finisher Frame.
Punch Relay
Harness
Harness
Guide
Harness
Clamp
Punch Relay
Harness
Finisher
Controller
Circuit
Board
Side
Guide
Front Cover
Screws
To Next Page
Loading...
