814
DP-C405/C305/C265
FEB 2008Ver. 1.1
Fig. 3-022
(7) Turn the Gear [16] to align the round hole in the
Staple Driver Gear with the Round Hole [17] at
the back.
Fig. 3-023
(8) Insert a Pin [18] with a diameter of
approximately 2 mm (use of a 2 mm Allen
wrench is recommended) in the Round Hole to
secure the Gear.
Fig. 3-024
(9) Turn the Gear [19] to align the Round Hole in the
Staple Clincher Cam with the Round Hole [20]
at the back.
[16]
[17]
[18]
[19]
[20]
To Next Page
