Parker AC30 - Page 289

Parameter Reference D-29
AC30 series Variable Speed Drive
Parameter Name
No.
Path
Default
Range
Units
Writable
The power parameters cannot be restored from a clone file that was saved on a control module with the parameter 0989 Power Stack
Required set to NONE.
Enumerated Value : Power Parameters
0 : LOAD FROM FILE
1: LEAVE CURRENT VALUES
2 : SET TO DEFAULT VALUES
Other Parameters
1540
Same as PNO 1534
0
0:LOAD FROM FILE
1:LEAVE CURRENT VALUES
2:SET TO DEFAULT VALUES
ALWAYS
If the parameter 1538 Full Restore is set to PARTIAL, then the parameter Other Parameters allows the user to load the ‘other’
parameters from the file, leave the current values or set the values to the defaults.
Enumerated Value : Power Parameters