Adjustment
139
Error 13: Sewing area larger than the work clamp cutout
Program does not fit into sewing area
Error 14: Output not connected (in seam program)
Error 15: Input not incoming (in seam program)
Error 16: Delay time when the sewing drive is running not permitted
Error 17: Cutting before previous sewing
Error 18: Incorrect command in data set
Error 19: Non-permissible program number / program number already allocated
Error 20: Needle thread breakage or needle thread inserted incorrectly
Error 21: Power unit overload (24 V)
Error 22: Incorrect mains voltage
Error 23: 24V power unit too low / or too high
Error 24: No stepping motor motion prepared (Nis)
Error 25: Stepping motor was not started (Nis)
Error 26: Incorrect knife length for multiple cutting
Error 27: Error in SD-memory card reader
27-1: No SD-memory card inserted
27-2: Wrong SD-memory card (does not match the machine)
27-3: SD-memory card not inserted correctly
27-4: SD-memory card with write protection
27-5: Data error on SD-memory card
27-6: Formatting failed
27-7: File does not match machine
27-8: Incorrect file size
27-9: Transfer error
27-10: Data cannot be deleted
29: Error during multiple cutting
To Next Page
Loading...
Need help?
General
