Setting up
38
9.07 Selecting the type of buttonhole / bartack
Depending on the selected operating mode, see Chapter 9.06 Selecting the operating
mode, the type of buttonhole or bartack is selected as described below.
Switch on the machine. ●
Select the input mode (LED in the key is on). ●
Select the function group " ● 100" with the appropriate plus / minus key.
Confi rm input with the "Enter" function by pressing the right ● plus key.
Select parameter " ● 105" ( type of buttonhole ) with the appropriate plus / minus key.
Select the desired buttonhole type ( ● 1-5) or bartack type (1-4) with the corresponding
plus/minus key:
Types of buttonhole
1 - seam raised, bartack fl at
2 - completely fl at
3 - completely raised
4 - fi rst sewing cycle completely fl at, second cycle completely raised ( double
sewing cycle )
5 - fi rst sewing cycle completely fl at, second cycle seam raised, bartack
fl at ( double sewing cycle )
Types of bartack
1 - 1st seam raised, 2nd seam fl at
2 - 1st and 2nd seam fl at
3 - 1st and 2nd seam raised
4 - 1st seam fl at, 2nd seam raised
Conclude parameter input by switching to operational mode Sewing (LED in the key goes ●
off).
No
100
No VAL
105 1
To Next Page
Loading...
Need help?
General
