Input
65
11 .06 Sequences
In a maximum of 3 different sequences, up to 33 vario programs in each sequence can be
combined in any order and processed later. Before sequences can be generated, appropriate
vario programs (buttonhole or bartack programs) have to be created, see Chapter 11.05
Vario programs. The sequences are arranged with parameters "111", "112" and "113", which,
in the sequence mode, are directly allocated to the appropriate keys on the control panel,
see Chapter 7.05 Control panel. Within the sequence the functions "cutting" and "double se-
wing cycle" can be allotted to the buttonhole programs.
11.06.01 Creating sequences
The following example describes how sequences are created.
Switch on the machine. ●
Select the input mode (LED in the key is on). ●
Select the function group " ● 100" with the corresponding plus/minus key.
Confi rm input with the "Enter" function by pressing the right ● plus key.
Call up parameter " ● 111" with the corresponding plus/minus key.
Confi rm input with the "Enter" function by pressing the right ● plus key.
Select the desired vario program, e.g. bartack program "T ● 3" with the corresponding plus/
minus key.
No
100
No
111
SEQ1
1T3 EXIT
To Next Page
Loading...
Need help?
General
