Input
66
Call up parameter " ● 114" (selection of the sequence mode) with the corresponding plus/
minus key and switch on the sequence mode (value "II").
Conclude the parameter input by switching to the sewing mode (LED in the key goes ●
off).
Call up next sequence position with the corresponding ● plus/minus key.
Select the next desired vario program, e.g. buttonhole program "B1" with the correspon- ●
ding plus/minus key.
Switch off the "cutting" function with the corresponding ● plus/minus key.
Call up next sequence position with the corresponding ● plus/minus key.
Select the next desired vario program, e.g. buttonhole program "B2 ● " with the correspon-
ding plus/minus key.
Switch on e.g. the "double sewing cycle" function (LED in the key is on). ●
Call up next sequence position with the corresponding ● plus/minus key.
The end of the sequence is defi ned by the string of characters "END" at the 4th sequence
position. The vario program "B2" is then recognized as the last program in the sequence.
Conclude the sequence input with the "EXIT" function. ●
SEQ1
2B1 IEXIT
SEQ1
3B2 IIEXIT
SEQ1
4END EXIT
No VAL
114 I I
To Next Page
Loading...
Need help?
General
