Adjustment
138
13.49 Malfunctions
13.49.01 Error messages
Error 1: System fault in the control unit
Error 2: Defect on sewing motor
30: Time out + motor defect
20: Time out + motor defect
10: Speed + motor defect
0B: StopX + motor defect
0A: Reset stitch counter + motor defect
9: Write parameter + motor defect
5: Position tdc shortest path + motor defect
3: Position tdc backwards + motor defect
2: Position tdc forwards + motor defect
Error 3: Knife control (e.g. mechanically locked)
Error 4: Cutter control
Error 5: Lift control of work clamp
Error 6: Time control when working through the sewing program
Error 7: Ramp end of stepping motor
7-1: Ramp end of stepping motor
7-1: Delay X not finished
7-2: Delay Y not finished
7-3: Delay X and Y not finished
7-4: Ramp X not finished
7-5: Ramp Y not finished
Error 8: Stitch length too large
Error 9: Sewing pattern outside area
Error 10: Error when moving the machine into basic position (home)
10-1: Outputs not finished
10-2: Raise work clamp
10-3: Start sewing position not reached
10-6: Foot pedal operated
10-7: X-centre not reached
10-8: still at X-centre
10-9: Y-centre not reached
10-10: still at Y-centre
10-11: time control home test
10-12: Absolute position –0.3 not reached home test
10-13: Absolute position +0.6 not reached home test
10-14: Move to tdc take-up lever
Error 11: Stepping frequency of the stepping motor is too high
Error 12: Error in sewing program
To Next Page
Loading...
Need help?
General
