Sewing
47
A seam correction value under the minimum cut distance to the bartack (see
parameter "210") or over the value for the appropriate subclass, is not valid.
Buttonhole
width
seam length
1/2 bartack
correctionr
1/2 bartack
correction
10.01.05 Altering the cutting width and cutting length correction
The cutting width and cutting length are only valid in the buttonhole mode and
must always be set up from the centre of the buttonhole.
Switch on the machine ●
Select the input of cutting width and cutting length correction (LED in the key is on). ●
Entering the cutting width correction
Enter the desired distance of the cut from the buttonhole seam with the left ● plus/minus
key.
Entering the cutting length correction
+0.4 +0.0
+0.4 +0.3
Enter the desired cutting length correction with the right ● plus/minus key. The buttonhole
length is adapted automatically to the corresponding length.
To Next Page
Loading...
