Sewing
49
To assign a program key, after selecting a variable or special program , press one
of the 3 program keys longer (approx. 2 seconds).
It is also possible to call up previously selected bartack lengths, vario or special
programs with the corresponding plus/minus key (also see Chapter 11.07
Selecting programs ). Selected programs are marked on the display with an " * ".
1500: Piece counter / reverse counter
Depending on the activated function (piece counter or reverse counter) the num-
ber of buttonholes already sewn or the number still to be sewn is displayed.
4000 12 . 0 1500
10.02.02 Selecting the bartack
The desired bartack is selected by entering the bartack length, bartack width and stitch
length.
Select the bartack length with the corresponding ● plus/minus keys.
Select the stitch density ●
Alterations in bartack width and stitch length for the forwards and reverse seam are
stored and can be called up again by pressing the corresponding program key.
If necessary, adapt the forward seam. ●
Enter the bartack width (left plus/minus key), stitch length (centre ● plus/minus key) and
bartack extension (right plus/minus key).
If necessary, adapt the reverse seam. ●
4.4 2.0 +0.5
4.4 2.0
Adapt the bartack width (left) and stitch length (right) of the rear seam with the corres- ●
ponding plus/minus keys.
To Next Page
Loading...
Need help?
General
