8 - 8
Mounting and commissioning the machine
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear
Fig. 8 - 14
● If necessary, correct the position of the sewing jig in the X-direction using the number
keys
according to the functions shown in the display.
● Set the value for the Y-direction at “0” and if necessary correct the position of the pocket
plate according to Chapter 13.06.05, Pocket plate position, front.
● Verify the input by pressing the Enter key and remove the blocking pin..
● Select Sewing mode.
If you have not entered and selected a sewing program (see chapter 9.06
Selecting a seam program) an error message will be displayed.
● Select the
basic position function.
(The machine is ready for operation.)
Enter
ENTER FOLDER POSITION
CONFIRM WITH ENTER KEY
X : 10 Y : 0
To Next Page
Loading...
