11 - 13
Input mode functions
CREATE / MODIFY PROGRAM
After the function has been selected, you can create and/or modify seam programs via
the control panel (see chapter 11.06 Creating / modifying seam programs).
COUNTER
Opens a menu for customizing the counters:
2
3
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear
Fig. 11 - 21
1 - RESET PIECE-COUNTER
2 - THREAD MONITOR .....
3 - SLOW START-STITCHES: 2 STITCHES
4 - CARRIAGE START (NIS): 90°
5 - START FOR THREAD TRIMMING: 220°
RESET PIECE-COUNTER
Resets the piece-counter to "0" for the daily production.
THREAD MONITOR
Opens a menu which allows you to change the counters for the thread monitor:
1
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear
Fig. 11 - 22
1 - SURPR.ST. NEEDLE THREAD MON.: 5 STITCHES
2 - SURPR.ST. BOBBIN THREAD MON.: 5 STITCHES
3 - STITCH REVERSAL: 10 STITCHES
4 - RESPONSE TIME, NEEDLE THR. MONITOR
SURPRESSED STITCHES NEEDLE THREAD MONITOR
Changes the number of stitches for which the needle thread monitor is not
active while the workpiece is sewn on.
SURPRESSED STITCHES BOBBIN THREAD MONITOR
Changes the number of stitches for which the bobbin thread monitor is not
active while the workpiece is sewn on.
STITCH REVERSAL
Changes the number of stitches which the needle automatically traces back
if a needle thread disturbance occurs.
RESPONSE TIME, NEEDLE THREAD MONITOR
This function is for changing the sensitivity of the needle thread monitor (1 =
quick response, max. sensitivity)
SLOW START-STITCHES
Changes the number of stitches which are to be sewn with reduced speed when
sewing on a section of the workpiece.
CARRIAGE START (NIS)
Changes the timing for starting the motors of the sewing jig feed (° = degrees
after needle bar at TDC, see Fig. 11-23).
2
1
2
3
3
4
4
To Next Page
Loading...
