Input mode functions
11 - 14
Needle pierces material,
carriage stops,
command for carriage
start is output approx. at
90°
Needle leaves the
material, carriage
start approx. at
270°
Needle in material,
continuous area of 180°
Fig. 11 - 23
The command for the carriage start is output when the needle pierces the
material. The carriage, however, starts half a revolution later (180°), when the
needle leaves the material.
Under certain conditions, the stitch formation can be influenced by
the setting.
START FOR THREAD TRIMMING
Changes the point in time at which the impulse to start thread trimming is sent to
the thread trimming valve (° = degree after needle bar at TDC).
SWITCH FUNCTIONS
Opens a menu for switching machine functions on and off.
5
Needle at TDC
4
1 2
3
4 5 6 7 9 0
Enter
8
Esc
Clear
1 - THREAD MONITOR .....
2 - LANGUAGE SELECTION .....
3 - OPTIONS .....
4 - CONTINUOUS CARRIAGE MOVEMENT: OFF
5 - LOCK / RELEASE FUNCTIONS
THREAD MONITOR
Opens a menu where you can select different thread monitors:
Fig. 11 - 25
1 - NEEDLE THREAD MONITOR: ON
2 - BOBBIN THREAD MONITOR: ON
3 - BOBBIN THREAD SENSOR: OFF
1
Fig. 11 - 24
To Next Page
Loading...
