User’s Manual of GS-4210 Series
Figure 4-9-21 Telnet Information Page Screenshot
The page includes the following fields:
Object Description
Telnet Service
Display the current Telnet service
Login Authentication List
Display the current login authentication list
Enable Authentication List
Display the current enable authentication list
Session Timeout
Display the current session timeout
Password Retry Count
Display the current password retry count
Silent Time
Display the current silent time
Current Telnet Session
Count
Display the current telnet session count
4.9.5.2 SSH
Configure SSH on this Page. This Page shows the Port Security status. Port Security is a module with no direct configuration.
Configuration comes indirectly from other modules - the user modules. When a user module has enabled port security on a port,
the port is set-up for software-based learning. In this mode, frames from unknown MAC addresses are passed on to the port
security module, which in turn asks all user modules whether to allow this new MAC address to forward or block it. For a MAC
address to be set in the forwarding state, all enabled user modules must unanimously agree on allowing the MAC address to
forward. If only one chooses to block it, it will be blocked until that user module decides otherwise.
The SSH Settings and Information screens in Figure 4-9-23 & Figure 4-9-24 appear.
233
To Next Page
Loading...
Need help?
General
