User’s Manual of GS-4210 Series
331
4.15.1 Power over Ethernet Powered Device
3~5 watts
Voice over IP phones
Enterprise can install POE VoIP Phone, ATA and other
Ethernet/non-Ethernet end-devices in the central area where UPS is
installed for un-interruptible power system and power control system.
6~12 watts
Wireless LAN Access Points
Museums, sightseeing spots, airports, hotels, campuses, factories, and
warehouses can install the Access Point anywhere.
10~12 watts
IP Surveillance
Enterprises, museums, campuses, hospitals and banks can install IP
camera without the limit of the installation location. Electrician is not needed
to install AC sockets.
3~12 watts
PoE Splitter
PoE Splitter splits the PoE 56V DC over the Ethernet cable into 5/12V DC
power output. It frees the device deployment from restrictions due to power
outlet locations, which eliminate the costs for additional AC wiring and
reduces the installation time.
3~25 watts
High Power PoE Splitter
High PoE Splitter splits the PoE 56V DC over the Ethernet cable into
24/12V DC power output. It frees the device deployment from restrictions
due to power outlet locations, which eliminate the costs for additional AC
wiring and reduces the installation time.
30 watts
High Power Speed Dome
This state-of-the-art design is considerable to fit in various network
environments like traffic centers, shopping malls, railway stations,
warehouses, airports, and production facilities for the most demanding
outdoor surveillance applications. Electrician is not needed to install AC
sockets.
Since the GS-4210 PoE Switch Series per PoE port supports 56V DC PoE power output, please
check and assure the Powered Device’s (PD) acceptable DC power range is 56V DC; otherwise, it
will damage the Powered Device (PD).
To Next Page
Loading...
Need help?
General
