16. Press Instrument spray to toggle between water & air, air and no spray.
The amount of water and air can also be programmed.
17. Press Chip blow to switch the automatic chip blow on or off. The amount
of water and air can also be programmed.
18. Press Instrument light to switch the instrument light on or off.
Results
NOTE
Changing the instrument spray, chip blow and instrument light values follows
the normal programming pattern. For more information, see sections
"Instrument spray" on page 176, "Automatic chip blow" on page 178 and
"Instrument light" on page 178.
When you have modified the settings of a preset, but have not saved them,
a dash (–) replaces the preset number on the control panel.
The procedure for saving the modified preset settings is explained in section
"Saving modified preset values" on page 183.
25.4.7.2 Saving modified preset values
About this task
When you have modified the Bien-Air MX2 instrument settings, you can
store them under any preset (1 - 6) so that the modified settings are in use
next time you select that preset.
Steps
1. Press Program.
2. Press Preset to open a list of presets.
3. Press the preset under which you want to store the modified settings.
The preset window is closed. The settings are stored in the dental unit
when you return the instrument to its holder.
25 Programming
User's manual Planmeca Compact i 183
To Next Page
Loading...
Need help?
General
