To Next Page

To Previous Page

9850067 R01 - 2020-2021 GENERAL / GENERAL XP Service Manual

2.55

BATTERY INSTALLATION

NOTICE

Using a new battery that has not been fully charged can

damage the battery and result in a shorter life. It can

also hinder vehicle performance. Refer to “Battery

Charging” page procedure before installing the

battery.

1. Place the battery in the battery holder and secure

with hold-down strap. Torque fastener to

specification.

TORQUE

Battery Bracket:

3.5 lb-ft (5 Nm)

2. Coat the terminals with dielectric grease.

3. Connect and tighten the red (+)

cable first.

4. Connect and tighten the black (-)

cable last.

5. Verify that cables are properly routed and reinstall the

driver’s seat.

BATTERY REMOVAL (INTL)

1. Remove the driver’s seat to access the battery

2. Disconnect the black (negative) battery cable.

CAUTION

To reduce the chance of sparks: Whenever removing

the battery, disconnect the black (negative) cable first.

When reinstalling the battery, install the black (negative)

cable last.

3. Disconnect the red (positive) battery cable.

4. Remove the battery hold-down bracket

. Lift the

battery out of the vehicle.

MAINTENANCE

Polaris General 2020 User Manual

Questions and Answers: