3
9850067 R01 - 2020-2021 GENERAL / GENERAL XP Service Manual
© Copyright Polaris Inc.
3.33
3. Remove the one-way clutch and inspect both sides
of drive rollers
q
. Inspect the roller contact surface
w
inside the hub for wear, damage or uneven
surface.
4. Inspect drive surface of starter gear
e
and bushing
r
for wear, damage or uneven surface. If any starter
one-way clutch component is worn or damaged,
replace the clutch and starter gear as an assembly.
CRANKCASE DISASSEMBLY /
INSPECTION
1. Remove the four screws retaining the oil cooler
q
to
the crankcase.
2. Remove the crankcase drain plug
w
. Drain any oil
remaining in the engine. Reinstall the plug.
3. Remove the oil filter.
4. Install the Cylinder Holding & Camshaft Timing Plate
(PU-50563)
e
onto the cylinder. The cylinder holding
tool retains the cylinder and pistons when the engine
is rotated.
5. Rotate engine to access the crankcase sump cover.
ENGINE / COOLING SYSTEM
To Next Page
Loading...
Need help?
General
