7.10
9850067 R01 - 2020-2021 GENERAL / GENERAL XP Service Manual
© Copyright Polaris Inc.
3. If adjustment is required, loosen the lower jam nut
y
and pull the cable out of the mount bracket to move
the upper jam nut
t
.
NOTICE
When adjusting the shift cable, the transmission should
be in park before making any adjustments.
4. Completely extend the shift cable and place the
adjustment pin approximately 2 mm past the shift
cable connection to ensure full extension in the park
position. Adjust the shift cable so there is the same
amount of cable travel when shifting slightly past
HIGH gear and PARK.
5. Thread the lower jam nut to the bracket face as
required to obtain proper cable adjustment.
NOTICE
This procedure may require a few attempts to obtain
the proper adjustment.
6. Once the proper adjustment is obtained, place the
shift cable and upper jam nut into the mount. Tighten
the lower jam nut against the mount. Then torque the
upper jam nut
y
to proper specification.
TORQUE
Shift Cable Jam Nut:
13 lb-ft (18 Nm)
7. Start engine and shift through all gears to ensure the
shift cable is properly adjusted. If transmission still
ratchets after cable adjustment, the transmission will
require service.
TRANSMISSION
To Next Page
Loading...
Need help?
General
