Connection Settings8.11
Connection to the Postage and E-Services Servers
To add funds or access myEquipment E-Services, the Mailing System can use the following
networks:
• An Internet access through a high speed LAN (Local Area Network).
First use the procedure below to select the connection, then configure the connection.
LAN settings can only be performed if the system was actually
connected to the LAN at power-up.
See also
• To physically connect the LAN to the base, see Detail of connections on page 19.
How to Set the Postage/E-Services Connection
To set the Postage/Online Services connection:
1. As supervisor (see How to Log in as Supervisor on page 154):
Press and select the path: Communication Settings Type of Connec-
tion
The Server Access screen is displayed.
If you did not have the LAN cable plugged into the system, you will
get a warning message.
Please follow the message: check your cable connections and
press OK.
2. Select LAN.
3. For LAN settings, see How to Set your LAN Preferences on page 182.
See also
• To physically connect the LAN to the base, see Detail of connections on page 19.
181
| Page 181 | | Jan-13-2017 10:45 |
8
Configuring your Mailing System
To Next Page
Loading...
