Running [Seal Only] Mail3.9
In Running [Seal Only] Section
This section describes the system settings to be selected and the mail preparation steps
to be completed in order to run your system in Seal Only Mode.
Seal Only Mode is used for:
• Sealing envelopes that do not require a Meter Impression or already have Meter
Impression.
• Conveying mail for Batch Counting or system testing purposes.
See also
• About the use of the Type of Impression, see How to Choose a Meter Impression on
page 25.
Setting [Seal Only] Mail processing
The instructions below outline the steps that you need to complete to set up your system
to run in Seal Only Mode.
• As mail requirements differ from day to day, some of the Impression Options may
not be necessary, or their order may vary.
• Begin by selecting a Meter Impression to gain access to the Impression Options that
you may need to process your system in Seal Only Mode.
Make sure you have completed the preparation steps mentioned
in Preparing and Starting your Job Run on page 29.
65
| Page 65 | | Jan-13-2017 10:45 |
3
Processing Mail
To Next Page
Loading...
