To Next Page

To Previous Page

Remote control commands

R&S

NRPxxS(N)

118User Manual 1177.5079.02 ─ 15

The "Upload Calibration Data" dialog opens. It shows a list of the available sen-

sors.

3. If you cannot find your power sensor in the list, for example because of reconnect-

ing the power sensor, you can reload the list by clicking "Rebuild List".

4. Click "Upload" to load calibration data from the power sensor.

After the upload is finished, the "OK" button is enabled.

5. Click "OK" to apply the changes.

If you want to discard the changes, exit the dialog by clicking "Cancel".

After a successful upload, the name and serial number are shown in the name of

the main dialog.

Configuring basic measurement parameters

Other manuals for R&S NRP Series

Questions and Answers:

Need help?

Do you have a question about the R&S NRP Series and is the answer not in the manual?

General