R&S ZNA67 - Page 1043

Command reference
R&S
®
ZNA
1043User Manual 1178.6462.02 ─ 20
Example:
*RST; :CALC:STAT:RES? MAX
Calculate and return the maximum of the default trace showing
an S-parameter on a dB Mag scale.
:CALC:FORM POL; STAT:RES? MAX
Display the trace in a polar diagram and re-calculate the maxi-
mum. The result corresponds to the previous result but is con-
verted to a unitless linear value.
Usage: Query only
Manual operation: See "Min/Max/Peak-Peak, Mean/Std Dev/RMS" on page 410
CALCulate<Chn>:STATistics:RMS[:STATe]
<Boolean>
CALCulate<Chn>:STATistics:SFLatness[:STATe] <Boolean>
These commands display or hide the "RMS" and the "Flatness/Gain/Slope" results in
the diagram area of trace no. <Chn>.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<Boolean> ON | OFF - statistical info field on or off.
*RST: OFF
Example: See CALCulate<Chn>:STATistics[:STATe]
Manual operation: See "Flatness/Gain/Slope" on page 412
7.3.1.21 CALCulate:TDIF...
Commands related to True differential mode.
CALCulate<Ch>:TDIF:IMBalance:COMPensation[:STATe] <Boolean>
Selects the calculation method for S-parameters, ratios and derived quantities during
an amplitude imbalance or phase imbalance sweep.
Suffix:
<Ch>
.
Channel number
Parameters:
<Boolean>
ON
Compensate imbalance of a waves (see "Imbalance Compensa-
tion of a-Waves" on page 250)
OFF
Use the actual a-waves, depending on the imbalance parame-
ters
*RST: OFF
Example: See SOURce<Ch>:TDIF:IMBalance:AMPLitude:LPORt
on page 1475
SCPI command reference