R&S ZNA67 - Page 1192

Command reference
R&S
®
ZNA
1192User Manual 1178.6462.02 ─ 20
<TraceFile> String parameter containing the path and file name of the bit pat-
tern file. If the path is omitted, the current directory is used (see
MMEMory:CDIRectory).
Usage: Setting only
Options: R&S ZNA-K20
Manual operation: See "Load Bit Stream" on page 741
MMEMory:LOAD:EYE:JITTer <TraceName>, <TraceFile>
Loads user-defined jitter from a 7-bit ASCII file into the generator simulation of an eye
diagram.
The file must consist of floating point values (in parsable format), separated by any
whitespace and/or line endings.
Setting parameters:
<TraceName> Name of the related eye diagram
<TraceFile> String parameter containing the path and file name of the jitter
file. If the path is omitted, the current directory is used (see
MMEMory:CDIRectory).
Usage: Setting only
Options: R&S ZNA-K20
Manual operation: See "User Specific" on page 748
MMEMory:LOAD:EYE:MASK <TraceName>, <TraceFile>
Loads a user-defined eye mask from a 7bit ASCII file.
Setting parameters:
<TraceName> Name of the related eye diagram
<TraceFile> String parameter containing the path and file name of the eye
mask file. If the path is omitted, the current directory is used (see
MMEMory:CDIRectory).
Usage: Setting only
Options: R&S ZNA-K20
Manual operation: See "Save / Load Mask Configuration" on page 756
MMEMory:LOAD:LIMit <TraceName>, <LimLineFile>[, <TouchstoneFile>[,
<StimulusOffset>[, <ResponseOffset>[, <LimLineType>]]]]
Loads a limit line definition from a specified file and assigns it to a trace with a speci-
fied name. Limit lines are created using the CALCulate<Ch>:LIMit... commands.
SCPI command reference