R&S ZNA67 - Page 1237

Command reference
R&S
®
ZNA
1237User Manual 1178.6462.02 ─ 20
The port type, further specified by its index <LocalIndex>
NONE
No LO source defined
RLO
The optional LO Out port at the rear panel of the R&S ZNA
PORT
A VNA port
GENerator
An external generator port
<LocalIndex> The LO source port index, if required.
For RLO the index is ignored.
Options: R&S ZNA-K8
Manual operation: See "Splitter <i>" on page 830
[SENSe:]CONVerter:SPLitter<Port>:LOSS
<Loss>
Defines the (cable and) splitter loss for splitter no. <Port>.
Suffix:
<Port>
.
Splitter number
Parameters:
<Loss> Loss value
Default unit: dB
Options: R&S ZNA-K8
[SENSe:]CONVerter<Port>:CSLoss <Loss>
Default cable (and splitter) loss for the local port of converter <Port>.
Suffix:
<Port>
.
Port number
Parameters:
<Loss> Default unit: dB
Options: R&S ZNA-K8
Manual operation: See "Cable & Splitter Loss" on page 833
[SENSe:]CONVerter<Port>:CSSLope <Factor>
Default slope factor for the local port of converter <Port>.
Suffix:
<Port>
.
Port number
SCPI command reference