R&S ZNA67 - Page 1338

Command reference
R&S
®
ZNA
1338User Manual 1178.6462.02 ─ 20
Manual operation: See "CW Mode Spectrum" on page 336
[SENSe<Ch>:]FREQuency:IMODulation:ORDer<Im>[:STATe] <Boolean>
Enables or disables the measurement of the intermodulation products of order <IM
order>.
Suffix:
<Ch>
.
Channel number
<Im> Order of IM products
Parameters:
<Boolean> ON | OFF – enables or disables measurement
*RST: ON (for <Im> = 3), OFF (for <Im> > 3)
Example: See [SENSe<Ch>:]FREQuency:IMODulation:LTONe
[SENSe<Ch>:]FREQuency:IMODulation:RECeiver <PortNumber>
Selects the receiving port for the intermodulation measurement.
Suffix:
<Ch>
.
Channel number
Parameters:
<PortNumber> Analyzer port number
Range: 1 to the number of analyzer ports
*RST: 2
Example: See [SENSe<Ch>:]FREQuency:IMODulation:LTONe
Manual operation: See "Receiving Port" on page 341
[SENSe<Ch>:]FREQuency:IMODulation:SPECtrum:MORDer <IMOrder>
Defines the maximum order of intermodulation products for the intermodulation spec-
trum measurement.
Suffix:
<Ch>
.
Channel number
Parameters:
<IMOrder> Maximum order of IM products
Range: 3 | 5 | 7 | 9
*RST: 3
Example: See [SENSe<Ch>:]FREQuency:IMODulation:SPECtrum[:
STATe]
Manual operation: See "CW Mode Spectrum" on page 336
SCPI command reference