R&S ZNA67 - Page 1488

Command reference
R&S
®
ZNA
1488User Manual 1178.6462.02 ─ 20
SYSTem:COMMunicate:RDEVice:AKAL:ADDRess:ALL?
Queries the names (USB addresses) of all connected calibration units.
Example: See SYSTem:COMMunicate:RDEVice:AKAL:ADDRess
Usage: Query only
Manual operation: See "Calibration Unit" on page 568
SYSTem:COMMunicate:RDEVice:AKAL:ADDRess:SUBModule:ALL?
If the calibration unit selected using SYSTem:COMMunicate:RDEVice:AKAL:
ADDRess is an inline calibration system (ICS), this query returns the addresses of the
connected ICUs. Otherwise it returns the empty string.
Example:
:SYSTem:COMMunicate:RDEVice:AKAL:
ADDRess 'ZN-Z30-02::100010'
Selects an ICS via its Inline Calibration Controller (ICC)
R&S ZN-Z30 (serial number 100010).
SYSTem:COMMunicate:RDEVice:AKAL:ADDRess:
SUBModule:ALL?
Returns something like:
'[1]ZN-Z33-02::101325,[2]ZN-Z33-02::
101325,[3]ZN-Z33-02::101339'
i.e. there are three ICUs of type R&S ZN-Z32 variant 02 connec-
ted to the ICC. For correct port assignment during calibration
([SENSe<Ch>:]CORRection:COLLect:AUTO:
ASSignment<Asg>:DEFine), the ICU with serial number
101325 is considered port 1, 101325 port 2, and 101339 port 3
of the ICS.
Usage:
Query only
SYSTem:COMMunicate:RDEVice:AKAL:CKIT <Characterization>
If the calibration unit selected using SYSTem:COMMunicate:RDEVice:AKAL:
ADDRess is an inline calibration unit (ICU), this command sets/queries the characteri-
zation to be used for calibrations with this ICU.
Parameters:
<Characterization> Name of a characterization of the related ICU
SCPI command reference