R&S ZNA67 - Page 1529

Command reference
R&S
®
ZNA
1529User Manual 1178.6462.02 ─ 20
TRIGger:CHANnel<Ch>:AUXiliary<n>:DELay <TrigOutDelay>
Specifies the delay of the trigger out signal relative to the selected sweep interval (see
TRIGger:CHANnel<Ch>:AUXiliary<n>:INTerval).
If pulses are used as trigger out signals (see TRIGger:CHANnel<Ch>:
AUXiliary<n>:STYPe), the delay is defined relative to the start or end of the sweep
event (see TRIGger:CHANnel<Ch>:AUXiliary<n>:POSition).
Suffix:
<Ch>
.
Channel number
<n> 1 = Trigger Out A, ..., 4 = Trigger Out D
Parameters:
<TrigOutDelay> Range: 0 to 30 s
Default unit: s
Example: See TRIGger:CHANnel<Ch>:AUXiliary<n>:INTerval
on page 1530.
Options: R&S ZNA-B91
Manual operation: See "Delay" on page 510
TRIGger:CHANnel<Ch>:AUXiliary<n>:DURation <TrigOutDuration>
If pulses are used as trigger out signals (see TRIGger:CHANnel<Ch>:
AUXiliary<n>:STYPe), this setting specifies the width of the output trigger pulses at
Trigger Out A to D.
The trigger duration must be shorter than the selected sweep interval (see TRIGger:
CHANnel<Ch>:AUXiliary<n>:INTerval).
If the trigger duration is too long, you can modify one of the following settings:
●
Reduce the trigger duration, if possible.
●
Slow down the sweep: select a smaller bandwidth or increase the "Sweep Time"
setting.
Suffix:
<Ch>
.
Channel number
<n> 1 = Trigger Out A, ..., 4 = Trigger Out D
Parameters:
<TrigOutDuration> Pulse width between 10 ns (1E-8 s) and 30 s.
*RST: 1 us
Default unit: s
Example: See TRIGger:CHANnel<Ch>:AUXiliary<n>:STYPe
on page 1531
Options: R&S ZNA-B91
Manual operation: See "Width" on page 510
SCPI command reference