GUI reference
R&S
®
ZNA
440User Manual 1178.6462.02 ─ 20
5.6.2.1 Controls on the Ripple Test tab
The "Def. Ripple Test..." button opens the "Define Ripple Test" dialog (see Chap-
ter 5.6.2.2, "Define Ripple Test dialog", on page 442).
Show Ripple Limits
Shows or hides the ripple limit lines associated with the active trace in a Cartesian dia-
gram area. The vertical positions of the ripple lines are recalculated after each sweep;
only their stimulus range and distance (the ripple limit) are fixed.
Note: Display of the limit line and limit check are independent of each other: Hiding the
limit line does not switch off the limit check.
Remote command:
CALCulate<Chn>:RIPPle:DISPlay[:STATe]
Ripple Check
Switches the ripple limit check of the active trace on or off.
Lines softtool
To Next Page
Loading...
