R&S ZNA67 - Page 76

Getting Started
R&S
®
ZNA
76User Manual 1178.6462.02 ─ 20
3.4.1.1 Connecting the instrument for transmission measurements
To prepare a transmission measurement, you have to connect your DUT (which for
simplicity we assume to have appropriate connectors) in-between a pair of analyzer
test ports. It is recommended that you preset the R&S ZNA to start from a well-defined
instrument state.
DUT
1 2
VNA
1 2
1. Connect the DUT between test ports 1 and 2 of the network analyzer as shown
above.
2. Use the [Preset] key to restore a well-defined instrument state.
The analyzer is now set to its default state. The default measured quantity is the
transmission S-parameter S
21
.
Select Trace – [Trace Config] and use the control elements in the "Traces" softtool tab
if you wish to create additional traces and diagrams.
Performing measurements